Mounting Bracket Installation - Vertex Standard VX-7200 Operating Manual

When installing the VX-7200 transceiver, make sure to plan the installation care-
fully and leave additional room in the rear of the radio for cabling and accessory
connections; in the front of the radio for access, controls, and cabling; and to the
sides of the radio so that you may access and install the Hex Head Bolts.

Mounting Bracket Installation

The supplied mounting bracket allows desktop or overhead mounting.
r Use a 7/32 inch (5.5 mm) bit to drill the holes to a surface which is more 0.4
inch (10 mm) thick and can support more than 3.3 lbs (1.5 kg) and secure the
bracket with the supplied screws, spring washers, flat washers, and nuts.
You may secure the bracket using the supplied tapping screws, instead of the
screws and nuts. In this case, drill the small pilot holes instead of the 7/32 inch
(5.5 mm) holes.
r Install the transceiver to the bracket using the supplied Hex Head Bolts.
Use only the supplied Hex Head Bolts, or equivalent size screws
(HSM4X8B).
d M
eskTOP
VX-7200 S
erieS
i
nsTAllATiOn
(
T s
OunT WiTh APPing
O M
perating
)
O
CreW verheAd
anual
(
M s
OunT WiTh CreW
)
& n
uT
9