EN
System Setup
Model Reset
Use the Model Reset menu to delete all model programming in
the active model memory. Reset returns all model settings to the
default settings and erases all programming in the selected model.
After a model reset, it is necessary to re-bind.
Sort Model List
With this function you can sort the model order in the model select
function. This is helpful to group similar models together to make
them easy to find. To move a model, highlight the model that you
wish to move with the scroll wheel, then press the scroll wheel to
select it. Scroll the scroll wheel to move the selected model to the
position desired. Press the scroll wheel when you have the model
in the position desired.
Warnings
The Warnings menu enables you to program a voice, tone or
vibration alert during power on of the transmitter for any selected
switch or channel position.
The alarm activates and an alert message appears on the screen if
a specific switch or control stick is in an unsafe position when you
power the transmitter on.
Return the switch or control stick to the safe position to silence the
alarm.
For safety reasons, the default throttle alarm activates if the
throttle position is above 10%.
•
Center In ±10 and Center Out ±10 have been added to the
warnings menu option. These can be adjusted to any value
between 1 and 99. An alarm can be put on a servo position that is
within a certain range of center, or outside a certain range around
center.
•
When adding channel position warnings, you can now enter
positions of up to 150% rather than the previous limit of 100%.
22
SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL