Operating The Appliance; Programme Data; Changing The Settings; Aquasensor - Bosch SMI88TS00G Instruction Manual

1
Operating the
appliance

Programme data

p l i a n c e O p e r a t i n g t h e a p
The programme data (consumption
values) can be found in the summary
of instructions. They refer to normal
conditions and the water hardness set
value °E 16 - 20 medium. Different
influencing factors such as water
temperature or line pressure may result
in deviations.

Changing the settings

The dishwasher has been preset with
certain settings for your convenience.
You can change these factory settings.
Change the setting as follows:
Open the door.
1.
Switch on ON/OFF switch (.
2.
Press Info button {8 for 3
3.
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing button >)* until the
4.
required setting is indicated on the
display window at the top @.
Make the setting with setting buttons
5.
+ -X.
Press and hold the Info button {
6.
8 for 3 seconds.
The chosen setting has now been
stored.
If you change several settings, first
Tip:
make all changes in succession. Now
press the Info button { 8 for
3 seconds. This saves all set values in
the appliance.
Operating the appliance en

AquaSensor *

* depending on the features of your
A q u a S e n s o r
dishwasher
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The AquaSensor is used according
to the programme. If the AquaSensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater,
the water is drained and is replaced
with fresh water. In the automatic
programmes the temperature
and running time can also be adjusted
to the degree of soiling.

Time display

The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme). You can change the time
display in time or hours/minutes so that
the remaining running time of the rinsing
progamme appears in the display
window "Ready at" (for example 15:20
hours) or "Ready in" (for example 3:25).
29