Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Led Lenser NEO
Summary of Contents for Led Lenser NEO
- Page 1 Lenser®* Operating Instructions...
-
Page 2: Table Of Contents
Lenser®* Table of Contents General Product Information Product Description Versions Scope of Delivery Range of Use Product Properties Important Notes on Safe Use Information Regarding Headlamp Identification Information Regarding Operating Instructions Identification Warranty Completeness 2.4.1 Damage Purpose of the System 2.5.1 Standards and Regulations 2.5.2 Intended Use 2.5.3 Target Group... - Page 3 Lenser®* Thank you We are delighted that you have decided in favor of one of our products. In these Operating Instructions you will find notes regarding safety and operation to help you to familiarize yourself with your new product. Carefully read these Operating Instructions prior to using this product. They should be kept and handed over to third parties when passing on the product to third parties.
-
Page 4: General Product Information
Headlamp NEO, • Blister pack, • General safety precautions and warnings, • NEO quick initial start guide, • 3 x AAA 1.5 V batteries. Range of Use Suitable for outdoor use. Protected against spray water from all sides (IPX4). EN Operating instructions NEO_V.01 | 7/31/2014... -
Page 5: Product Properties
Lenser®* 1. General Product Information Product Properties • Extremely low weight, • 16:9 Bright & Wide Beam ② with particularly wide radiation angle ① and bright illumination, • Smart Light Technology (SLT) ③ with 3 different lighting modes (Power / Low Power / Blink) for the front light, rear red flashing light (LED) ④... -
Page 6: Important Notes On Safe Use
(printed, data format or in excerpts). Warranty Warranty LED LENSER ensures the safety and proper functioning of the headlamp only under the condition that: • The headlamp is only used according to the intended purpose and... -
Page 7: Intended Use
- Part 1: General principles and detailed requirements. 2.5.2 Intended Use NEO is a high-performance headlamp with a light cone. It is designed to enable you to see and be seen in the dark, for use as emergency light or to read in the dark. •... -
Page 8: Safety Notes
Lenser®* 3. Safety Notes Safety Notes Structure Important notes are marked with pictograms and signal words in these Operating Instructions. 3.1.1 Risk of Injuries Markings Signal words, such as DANGER, WARNING or CAUTION designate the grading of a potential risk of injuries. The different triangle symbols emphasize the level of risk optically. - Page 9 Lenser®* 3. Safety Notes Health risk 1 WARNING IMPAIRMENT CAUSED BY THE FLASHING FUNCTION When using the flashing function, dizziness, vision-impairment, convulsions, loss of consciousness, disorientation or cramps may occur. Therefore: • In the event that one of the symptoms mentioned above occur, immediately switch off the flashing function/headlamp.
- Page 10 Lenser®* 3. Safety Notes 1 CAUTION RISK OF INJURY Do not wear the headband around the neck. Do not use headlamp or accessories if they are damaged, since there is a risk of injury. Therefore: • Take damaged parts out of operation and replace or have them repaired professionally.
- Page 11 Lenser®* 3. Safety Notes displayed markings (+/-). • Remove from the headlamp if you will not be using it for some time or if they are empty. What to do: → In the event of leaking batteries, place a cloth underneath and prevent the skin, eyes and mucous membranes from coming into contact with battery fluid.
-
Page 12: Overview Of Terms And Abbreviations
Lenser®* 3. Safety Notes Therefore: • Submit headlamps in to a local collection point for the recycling of electrical and electronic devices. • Submit used batteries/battery packs to a local battery collection point or anywhere where batteries/battery packs are sold. •... -
Page 13: Operation
Lenser®* 5. Operation Adapting the Headband Width 1. In order to extend the headband ④ further, hold the band adjustment ③ between the fingers and pull the headband ④ in direction of the battery cover ⑥ until the headband ④ has reached the desired length. 2. -
Page 14: Using The Lighting Functions
Lenser®* 5. Operation Using the Lighting Functions The headlamp has 2 LEDs, a white LED ③ on the front (in the lamp head ①) and a red LED ⑤ on the rear battery box ④. This enables a white front light for illumination and an optional flashing red warning light at the rear. -
Page 15: Replacing The Batteries
Lenser®* 5. Operation Replacing the Batteries The battery box ① is located at the rear of the headlamp for optimal weight distribution. 1. Pull back the flexible battery cover ② of the battery box ① on the side labeled ”Open” to replace the batteries. 2. -
Page 16: Checks
Lenser®* 5. Operation ATTENTION WARRANTY EXEMPTION No warranty will be assumed for damage resulting from the use of inappropriate cleaning agents or disinfectants. Checks Every product is prone to wear over time. Annually, and prior to each use, check the safety and function of the headlamp as well as the batteries/battery packs. -
Page 17: Technical Data
Lenser®* 6. Technical data Parameter value Value 1 x High End Power LED Weight 54 g (without batteries) / 80 g Batteries 3 x AAA 1.5 V, use of battery pack (NiMH) possible Energy tank*** 5.4 Wh Lighting modes Power Low Power Flash Luminous flux*... - Page 18 ZWEIBRÜDER OPTOELECTRONICS GMBH & CO. KG ® Kronenstr. 5-7 • 42699 Solingen • Germany Tel. +49 212 / 5948 - 0 • Fax +49 212 / 5948 - 200 info@zweibrueder.com • www.zweibrueder.com...