Table of Contents
Advertisement
and wiring away in such so that they
will not obstruct or hinder driving.
Make sure that the cables and wires
will not interfere with or become
caught in any of the vehicle's moving
parts, especially the steering wheel,
shift lever, parking brake, sliding seat
tracks, doors, or any of the vehicle's
controls.
Do not route wires where they will
be exposed to high temperatures. If
the insulation heats up, wires may
become damaged, resulting in a short
circuit or malfunction and permanent
damage to the product.
Do not shorten any leads. If you do,
the protection circuit (fuse holder,
fuse resistor or filter, etc.) may fail to
work properly.
Never feed power to other electronic
products by cutting the insulation of
the power supply lead of this prod-
uct and tapping into the lead. The
current capacity of the lead will be
exceeded, causing overheating.
Before installing this product
Use this unit with a 12-volt battery and
negative grounding only. Failure to do so
may result in a fire or malfunction.
To avoid shorts in the electrical system,
be sure to disconnect the (–) battery
cable before installation.
To prevent damage
WARNING
Use speakers over 50 W (output
value) and between 4
to 8
(impedance value). Do not use 1
to
3
speakers for this unit.
The black cable is ground. When
installing this unit or power amp
(sold separately), make sure to con-
nect the ground wire first. Ensure
that the ground wire is properly
connected to metal parts of the car's
body. The ground wire of the power
amp and the one of this unit or any
other device must be connected to
the car separately with different
screws. If the screw for the ground
wire loosens or falls out, it could
result in fire generation of smoke or
malfunction.
Ground wire
POWER AMP
Other devices
Metal parts of car's body
(Another electronic
device in the car)
When replacing the fuse, be sure
to only use a fuse of the rating pre-
scribed on this product.
This product cannot be installed in a
vehicle without ACC (accessory) position
on the ignition switch.
ACC position
No ACC position
To avoid short-circuiting, cover the
disconnected lead with insulating tape.
It is especially important to insulate all
unused speaker leads, which if left uncov-
ered may cause a short circuit.
For connecting a power amp or other
devices to this product, refer to the man-
ual for the product to be connected.
■ Notice for the blue/white lead
When the ignition switch is turned on
(ACC ON), a control signal is output
through the blue/white lead. Connect to
an external power amp's system remote
control terminal, the auto-antenna relay
control terminal, or the antenna booster
power control terminal (max. 300 mA
12 V DC). The control signal is output
through the blue/white lead, even if the
audio source is switched off.
Chapter
27
57
En
Advertisement
Table of Contents
