Change Tv Preferences; Access Decoder Channel; Start A Tv Demo - Philips 19PFL3404H/12 User Manual

• Select [Update now] to update the
software immediately.
• Select [Remind me later] to exit the
update screen at that time and be
reminded later.
• Select [Cancel] to skip the update.
2
If you select [Cancel], you can manually
access the OAD update by selecting
[Setup] > [Software update] > [Local
updates] > [OAD].
3
Select the available version of OAD and
press OK.
4
Follow the on-screen instructions to start
the update.
Note
• The TV restarts after the software update is
complete.

Change TV preferences

1
Press MENU.
2
Press to select [Setup] >
[Installation] > [Preferences].
3
Press OK or
• [Location]Optimises TV settings for
your location - home or shop.
• [Volume bar]Displays the volume
bar when adjusting the volume.
• [Channel info.]Displays information
about the TV channel every time you
switch channels. Select [Full] to view
channel information or [Off] to turn
off the channel information.
• [EasyLink]Enables one-touch play
and one-touch standby between
EasyLink-compliant devices.
• [E-sticker]For shop mode only. Sets
the location of the e-sticker.
22 EN
to enter [Preferences].

Access decoder channel

You can map channels provided through a
decoder or descrambler to your TV channel
selection. In this way, you can select these
channels by using the RC of your TV. The
decoder or a descrambler must be connected
to EXT1 (SCART).
Set decoder channel
Map channels from a decoder or descrambler
1
Press MENU.
2
Press to select [Setup] >
[Installation] > [Preferences] >
[Decoder].
3
Press OK or
.
4
Press to select [Channel] and press
OK or to enter.
»
A list of analogue channels appears on
the screen.
5
Press to select one channel to map
to the decoder/descrambler channel and
press OK to confirm.
6
Select [Status] and press OK or
enter.
7
Press to select [EXT 1] (SCART)
the connector used by the decoder/
descrambler.
8
Press OK.
9
Press MENU to exit.

Start a TV demo

1
Press DEMO on the remote control.
2
Press to select a demo and press OK
to view it.
3
Press DEMO to exit.
to enter [Decoder] menu
to