Scalemaster Softline 100 Installation And Operation Manual
Hide thumbs
Also See for Softline 100:
- Installation procedures & operating manual (12 pages) ,
- Installation procedures & operating manual (12 pages)
Related Manuals for Scalemaster Softline 100
Summary of Contents for Scalemaster Softline 100
- Page 1 Softline 100 Softline 200 Softline 100t Softline 200t Installation and Operation Manual...
- Page 2 Contents Page Introduction Congratulations on your excellent choice of a Scalemaster Water Softener. Introduction Please take the time to read this Manual. It will tell you in simple terms how to install and commission your new Scalemaster Water Softener to begin enjoying the benefits of Installation softened water. Before You Start Controls: Layout and Operation ●...
-
Page 3: Drain Line Connection
Water Softener. Where practical this ● Your Scalemaster Water Softener is designed to operate with an incoming water should be at the kitchen sink but a Utility Room or other suitable alternative will pressure of between 1.0 bar and 8 bar. If your water supply is likely to fall outside... - Page 4 Controls: Layout and Operation Valve Layout (Back) Drain (May have right ● Large LED Display: The 2 digit LED readout is highly visible for easy reading. Outlet 3/4” Inlet 3/4” angled connector) BSPT BSPT 1/2” BSPT ● Easy 3-Step Programming: Only 3 buttons are required to fully control the softener.
- Page 5 Easy 3 - Step Programming Softline 100 Meter TABLE A (100 METERED) Hardness STEP 1 (Metered & Timed) Cu Meters Capacity Time of Day: Press until desired hour appears (see Fig 4). Release. TABLE A (200 METERED) Softline 200 Meter Note: The elapsed minutes will reset to zero when the hours are changed.
- Page 6 Commissioning: Manual Regeneration and Start-Up 3. Filling the vessel with water. A. With the Softener in backwash, open the water supply valve very slowly to Delayed Regeneration: Press and release approximately open position. Water will begin to enter the vessel. Air program a delayed regeneration (Fig 7).
- Page 7 SOFTLINE 100 SOFTLINE 100t SOFTLINE 200 SOFTLINE 200t SPECIFICATION Height 445mm 445mm 600mm 600mm Depth 460mm 460mm 460mm 460mm Depth Including Connectors 460mm 460mm 460mm 460mm Width 275mm 275mm 270mm 270mm Resin Volume 10 litre 10 litre 15 litre 15 litre Salt used per regeneration cycle...
Need help?
Do you have a question about the Softline 100 and is the answer not in the manual?
Questions and answers