Advertisement
19
Lift Canopy to ceiling aligning the key hole slots
with the screws on the bottom of the Mounting
bracket. Rotate the canopy Counter Clockwise
to lock in place. Tighten the screws to secure
the Canopy. See inset for Keyhole shape
23
Loosen 2 screws and remove 1 screw
from motor plate. Save removed
screw for use later.
26
Connect plug from fan to switch
housing plug.
29
Remove twin adhesive tape from the
black capacitor as shown above.
20
Attach blade brackets to blades using
the blade bracket screws and wash-
ers provided.
24
Thread capacitor and 9 pin plug
through switch housing plate.
27
Remove switch housing screws.
30
Place and press firmly on the capaci-
tor to stick it to the switch housing.
Be sure it is secure.
22
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present.
Attach blade assembly to motor using the
motor screws and washers provided. Tighten
screws securely.
25
Install by twisting clockwise, replace
screw removed from motor plate.
Tighten all 3 screws securely.
28
Black capacitor box needs to be
stuck to the switch housing. Not
being attached can cause motor
noise.
31
Install switch housing cap using
screws removed. Tighten securely.
Advertisement
