Panasonic CF-MX4 series Operating Instructions Manual page 28

Troubleshooting (Basic)
■
Starting Up
You have forgotten the
password.
"Remove disks or other
media. Press any key to
restart" or a similar message
appears.
The date and time are
incorrect.
[Executing Battery
Recalibration] screen appears.
28
●
Supervisor Password or User Password: Contact Panasonic
Technical Support.
●
Administrator password:
•
If you have another account with Administrator authority, log-on
with it, then delete the password for the problem account.
•
If you have a password reset disk, click [Reset password]
displayed after the password input error, then follow the on-
screen instructions and set a new password.
If you cannot do either of the above, you will need to reinstall
(è page 21) and setup Windows.
●
A floppy disk in the drive or USB memory is connected, and it
does not contain system startup information. Remove the floppy
disk and USB memory, then press any key.
●
If a device is connected to the USB port, disconnect the device,
or set [USB Port] or [Legacy USB Support] to [Disabled] in the
[Advanced] menu of the Setup Utility.
●
If the problem persists after removing the disk, it may be a flash
memory drive failure.
Perform the installation and return the flash memory drive to its
condition at the time of purchase. (è page 21) If the problem
persists even after the reinstallation, contact Panasonic Technical
Support.
●
Make the correct settings.
Open the Control Panel.
1. Perform either of the following procedures.
●
For the desktop screen:
Right-click
screen.
●
For the Start screen:
Click on the Start screen.
2. Click [Control Panel].
Click (Start) - [Control Panel].
Click [Clock, Language, and Region] - [Date and Time].
Click [Change time zone...].
Select the time zone, then click [OK].
Click [Change date and time...], then set the date and time.
●
If the problem persists, the internal clock battery may need to be
replaced. Contact Panasonic Technical Support.
●
When the computer is connected to LAN, check the date and time
of the server.
●
The 2100 A.D. or later year will not be correctly recognized on this
computer.
●
The Battery Recalibration was canceled before Windows was
shut down last time.
To start up Windows, turn off the computer by the power switch,
and then turn on.
at the bottom left corner of the Desktop