Advertisement
19
Remove 2 screws in yoke (see
insert). Remove 3 screws with key-
hole slots from top of fan.
22
Hands free hook
Hang fan from mounting bracket by
the hands free hook into a closed
hole on the edge of the Canopy.
Note: For Canadian mounting refer to
Step #10.
25
Install blades and blade plates to
motor using the 9 motor screws pro-
vided. Tighten screws securely.
28
Connect plug from fan to switch
house plug.
20
Center
Hole
Smaller
holes
Place canopy on top of the fan motor allowing the
yoke, wires and safety cable to pass through the
large hole in the center of the canopy. Align the 3
larger holes around the center hole with the 3
screws still installed in the fan. Install 3 screws
removed into small holes in canopy to make it a
flush mount canopy and tighten screws securely.
23
Lift fan to mounting bracket, aligning the "L"
shape holes with the scresws on the mount-
ing bracket. Turn the fan clockwise to lock
in position. Install the other two screws and
tighten securely.
26
Loosen 2 screws with key slots and
remove 1 screw without slot from
motor plate and save screw.
29
Remove 3 screws and save to install
switch housing.
21
Canopy
Larger
holes
Install two screws corresponding with the
"L" shaped holes in the canopy only part
way so that canopy can twist into place.
Remove the all thread studs from the
lower part of the mounting bracket.
24
Align the blade and then the blade
plate with castings on motor to
attach blades to motor.
27
Install switch housing plate by twist-
ing plate with key hole slots into
place. Replace screw removed and
tighten the 3 screws securely.
30
Install the switch housing using the
3 screws previously removed.
Blade plate
Advertisement
