Monster Power PowerSource Signature HTPS 7000 MKII Owner's Manual page 32

Symptom
"Timed On"
indicator on front
panel is Off.
Video picture
has rolling bars
or ghosting.
The PowerSource
is emitting a loud
buzzing alarm.
24
TROUBLESHOOTING
Possible Cause
You are using the Remote Turn-On feature
(Same as Switched) and haven't plugged
the plug into the component you wish to use
to activate the Remote Turn-On.
The component remote control you are using
to power the Remote turn-on has a dead battery.
The component you wish to use to activate the
Remote Turn-On isn't plugged into a properly
grounded 120 volt (nominal) outlet.
The incoming video signal is
not properly grounded.
The PowerSource protection circuitry has
sacrificed itself to protect connected equipment
from a catastrophic surge.
Remedy
• Plug the plug into component you
wish to use to activate the Remote
Turn-On.
• Replace the battery powering
the component remote control.
• Plug the component into a properly
grounded 120 volt (nominal) outlet.
• Contact your cable or satellite
provider to correct your installation.
• The PowerSource must be replaced.
See the Warranty Information section
for important details.