Troubleshooting - Monster Power PowerSource Signature HTPS 7000 MKII Owner's Manual

Symptom
The PowerSource is
not receiving power.

TROUBLESHOOTING

Possible Cause
The PowerSource
is not turned On.
Too many devices are
connected, causing an
overload, tripping the
Thermal Circuit Breaker.
Remedy
• Turn the PowerSource switch on.
• Make sure the PowerSource's AC power plug
is plugged into a properly grounded 120 volts
(nominal) wall outlet.
• In some households, a wall switch may need
to be thrown to make the wall plug active. Try
turning on the light switches located near the
wall unit.
• Press the PowerSource Thermal Circuit Breaker
button in to reset. Please allow
10 minutes before attempting to reset.
If you reset too soon, the breaker will
prematurely sense power overload and
not allow unit to operate.
• If the Circuit Breaker continues to trip,
try moving one or more components
to another PowerSource. You may be drawing
too much current through one PowerSource.
21