Monster Power PowerSource Signature HTPS 7000 MKII Owner's Manual page 31

Symptom
The Unswitched LED
on front panel is Off.
The Switched LED is Off.
TROUBLESHOOTING
Possible Cause
The PowerSource is not plugged in.
The PowerSource is plugged in,
but the outlet is not receiving power.
You are using the Switched Outlet
Remote Turn-On feature and haven't
plugged the plug into the component
you wish to use to activate the
Remote Turn-On.
The component remote control
you are using to power the Remote
turn-on has a dead battery.
The component you wish to use
to activate the Remote Turn-On
isn't plugged into a properly grounded
120 volt (nominal) outlet.
Remedy
• Plug the PowerSource into a
properly grounded 120 volts
(nominal) outlet and make sure it
is on.
• Plug the plug into the component
you wish to use to activate
the Remote Turn-On.
• Replace the battery powering
the component remote control.
• Plug the component into a properly
grounded 120 volt (nominal) outlet.
• Plug the PowerSource into
a properly grounded 120 volts
(nominal) outlet.
23