Troubleshooting - Monster Power HTPS7000 Owner's Manual

PROBLEM – The PowerSource is not receiving power.
Possible Cause #1:
The PowerSource is not turned on.
Possible Solutions:
• Press the "ON/OFF" button on the PowerSource.
• Make sure the PowerSource's AC power cord is plugged into a properly grounded 120V wall outlet.
• In some households, a wall switch may need to be thrown to make the wall outlet come alive. Try turning on
the light switches located near the wall outlet powering the PowerSource.
Possible Cause #2:
Too many devices are connected, causing an overload, throwing the thermal circuit breaker. Please note that the
total power consumption of all the components powered by the PowerSource should not exceed 1800 watts.
Possible Solutions:
• Press the PowerSource's thermal circuit breaker (labeled "BREAKER 15A" on the back panel) button in to reset.
• Allow 10 minutes from the time the circuit breaker is initially thrown before attempting to reset it. If you reset
too soon, the breaker will prematurely sense power overload and not allow the unit to operate..
• Disconnect any component that may be overloading the PowerSource.
22

TROUBLESHOOTING