Pre-Print Checks; Power Up - mbot 3d CUBE User Manual

MagicFirm
2 2 2 2 Pre-print Pre-print Pre-print

Pre-print checks

2.1 2.1 2.1 Power 2.1 Power

Power up

Power up up up
1) Ensure the power cable is attached (see the picture below), and then switch
on.
2) The LCD screen reads "Heater Error!", which can be fixed by heating up
through software.
Press any botton at the right hand and you'll see the messge changes on the LCD,
checks checks
checks
Technical Support： info@mbot3d.com
9