This Chapter); Test Print - mbot 3d CUBE User Manual

MagicFirm
Test Test print print
4 4 4 4 Test

Test print

printing
printing, please printing, printing, printing, please please please read
Please test nozzles before your first printing, which is required for first printing
only.
1) Click the button as shown below, to open the control panel.
The control panel pops up.
2) Once the nozzle is at temperature (220° C), load filament as shown below.
Click "Forward" button, and then take the filament and push it. You'll have to use
some force. After a few moments you should feel the motor pulling it in. Then let go.
You'll see some plastic start to come out the nozzle.
When that happens,.you may hear the noise like "tah-tah-tah" . Please maintain
pressure on the filament for 25 seconds. Then the noise will disappear. It also works
when changing material.
ing ing
ing
If If If If plastic plastic plastic
plastic stop
( ( ( (
read read this read this this this chapter chapter chapter chapter
) ) ) )
Technical Support： info@mbot3d.com
stop stop com com ing ing out out
stop com coming ing out out the
the the nozzle nozzle during during
the nozzle nozzle during during
19