Generating Gcode（Slicing - mbot 3d CUBE User Manual

MagicFirm
3.3 3.3 3.3 Generating 3.3 Generating Generating Generating GCode
1) Click the "Generate GCode" button at the lower right corner of the window.
Then the following prompt pops up, if the model is adjusted but not saved. Click
"Yes" to save changes. Otherwise, click "No".
But But please please click click " " " " Cancel click
But But please please click
example.We example.We example.We example.We have have have to to to to make have
2) After clicking "Generate GCode", the following window pops up. Red arrows
point to our helpful hints.
Set up as shown above. Then click "Default " tab to set up as shown below.
GCode（ （ （ （ Slicing Slicing） ） ） ）
GCode GCode Slicing Slicing
Cancel" " " " and Cancel Cancel and and reopen reopen
and reopen reopen the
make sure make make sure sure the sure the the the model model model model size
Technical Support： info@mbot3d.com
the the sample sample file, file, if if if if you file,
the sample sample file,
size size size is is is is proper proper proper for proper for for holding for holding ABS holding holding
you' ' ' ' re re re re following you you following following our our
following our our
ABS ABS ABS material. material. material. material.
16