Chapter 3. Disassemble And Assemble; Remove The Stand; Remove The; Remove The Adhesive Tape - Haier HL32K2 Service Manual

Chapter 3. Disassemble and Assemble

3-1 Remove the Stand

1. Lay down the unit so that back cover faces
upward
2. Remove the four screws from the back
cover which are indicated with the circles in the
picture above.
3. Remove the stand
3-2. Remove the Back Cover
1. Remove the twelve screws indicated (See
picture right.)
2. Then remove the back cover from the unit.

3-3. Remove the Adhesive Tape

The location of the adhesive tape is shown
below.
Remove the adhesive tape.
Service Manual
Model No.: HLC32K2
11