Subaru 2003 LEGACY Service Manual page 9

C: CAUTION
• Before disassembling or reassembling parts,
always disconnect battery ground cable. When
repairing radio, control module, etc. which are
provided with memory
memory contents before disconnecting battery
ground cable. This is to prevent from memory
loss caused by disconnection of ground cable.
• Reassemble parts in reverse order of
disassembly procedure
indicated.
• Adjust parts to specifications contained in
this manual if so designated.
D: PREPARATION TOOL
1. SPECIAL TOOLS
ILLUSTRATION
ST-925580000
2. GENERAL TOOLS
TOOL NAME
Circuit Tester
Drill
GENERAL DESCRIPTION
functions, record
unless otherwise
TOOL NUMBER DESCRIPTION
925580000 PULLER
SL-7
• Connect connectors and hoses securely
during reassembly.
• After reassembly, ensure all functional parts
operate smoothly.
• Airbag system wiring harness is routed near
the electrical parts and switch.
• All airbag system wiring harness and
connectors are colored yellow. Do not use
electrical test equipment on these circuits.
• Be careful not to damage airbag system
wiring harness when servicing the ignition key
cylinder.
Used for removing trim clip.
REMARKS
Used for measuring resistance and voltage.
Used for replacing ignition key lock.
SECURITY AND LOCKS
REMARKS