Installing The Optical Engine - Mitsubishi Electric WD-52525 Part Replacement Instructions

MITSUBISHI INSTRUCTIONS: V26/VK26 ENGINE REPLACEMENT

Installing the Optical Engine

1) Remove the Bottom Plate, Black Support
Bracket, Lamp Housing Grill and the Heat
Sensor from the original Optical Engine and
install on the replacement Engine.
2) Transfer the Lens Cap from the replacement
Engine to the original Engine.
3) Reverse the removal procedure to install the
replacement Optical Unit in the cabinet.
(See diagram to the right for reference)
The Optical Engine is mounted on the Adjuster assembly
as shown in the diagram to the right.
1) The Optical Engine is secured to the bottom plate by
4 screws (b).
2) The Black Bracket is secured to the bottom plate and
the Lamp Housing with 4 screws (c).
2) The bottom plate tab (1) slides into slot (1) on the
Adjuster.
3) Four screws (a) secure the bottom plate and Optical
Engine to the Aduster assembly.
4) Two screws secure the Lamp Housing Grill.
5) To replace the Optical Engine, only the bottom plate,
black bracket and the Optical Engine need to be
removed.
Black Bracket
(C)
Front View
Figure 3: Black Support Bracket
Mitsubishi Digital Electronics America, Inc
Lamp Housing
Grill (2 screws)
Page 5