Setting The Rinse Aid Dosage - Miele G 4970 Operating Instructions Manual

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
The dosage can turn out to be higher
than the set value due to the automatic
adjustment of the Automatic program.
If spots appear on dishware and glass‐
ware:
Increase the rinse aid dosage.
If clouding or smearing appears on
dishware and glassware:
Decrease the rinse aid dosage.
Before using for the first time
Turn the dishwasher off with the
button, if it is turned on.
Press the program selection button
, and, simultaneously switch the
dishwasher on using the
Keep the program selection button
pressed in for at least four seconds
until the lower right program indicator
light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
Press the
The indicator light will flash 3 times
at short intervals.
The set value will appear in the display
after .
The flashing sequence
the display.
This indicates a factory default setting
of 3.
Use the program selection button
to select the setting required.
Each press of the button moves you
up a level.
The setting is now stored in memory.
Turn the dishwasher off with the
button.
button.
button 3 times.
will appear in
19