Electrical Installation; Remote Wall Mounted Switch; Remote Wall Switch; Optional Dc Remote Systems - Monessen Hearth CDV7 Installation And Operating Instructions Manual

Cdvsc7 series, cdv7 series, direct vent gas fireplace

Hide thumbs

Table Of Contents

Table of Contents

CDVSC7 & CDV7 Series Gas Fireplace

ReMoTe wall MounTeD SwITCh

A remote wall switch and up to fifteen (15) feet of 18 Ga. wire

may be used with this appliance. Attach the wall switch in a

junction box at the desired location on the wall. Figure 43. Do

not extend beyond the wall switch wire length provided.

noTe: Extended lengths of wire may cause the fireplace not

to function properly. Longer length of wire is permitted if the

wire is made out of larger gauge (diameter) wire. Always check with local code.

PILOT

TH/TP

Figure 43 -

Wiring Diagram for Wall Switch

ReMoTe wall SwITCh

Position the wall switch. Do not extend beyond the 15 feet

of wire.

opTIonal DC ReMoTe SySTeMS

See section entitled Hearth Mount in the Millivolt hand held

remote instructions supplied with the remote.

1. Using a flat head screw driver, bend the "remote" tabs

up from the bottom of the fireplace. Figure 44

. Follow the instructions on remote control to snap the

remote cover plate to the remote receiver

3. Connect the wire terminal from the remote receiver.

Figure 43

4. Use the screws that came with the remote control to

mount the remote receiver cover to the bent up "remote"

tabs. Figure 44

OFF

FP1980

Dv wiring diagram

'Remote' Tabs

Remote Control

Receiver

Figure 44 -

Optional Control Location