Setup Guide WARNING: Drum key can be pinched when adjusting clamps with drum key. Operate carefully. Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers. Check the include items CYMBAL PADS BOX HI-HAT PEDAL BOX Cymbal Pad with choke x 2 Cymbal Pad x 1...
Page 2
Attach the Parts Attach the Pads Side Arm(L1) Wing Nut 1.Loosen wing nut on the holder clamp, which is on the center Center Pipe(1) pipe(1),side arm(L2)and side arm(R). 2.Attach drum pads to the holder Side Arm(L2) clamp on center pipe(1),side Center Pipe(2) arm(L2),side arm(R) and tighten Side Arm(R)
Page 3
Connect the Pads to the Drum Module Attach the Drum Module 1. Connect the cable to the drum module as shown with hands crews. 2. Attach the drum module to the mount holders on Side Arm (L1), and firmly tighten the relevant wing nut. Note: Adjust the drum module position by moving the mount holders as needed, and firmly tighten the relevant wing...
Need help?
Do you have a question about the DD403 and is the answer not in the manual?
Questions and answers