GE DPSE592EA0 Technical Service Manual page 39

1. How do you get into the Field Service Mode for
the Wizard Dryer?
a) Press & hold "Start/Pause" button for 3
seconds
b) Press & hold "DeWrinkle/Air Dry" buttons for
3 seconds
c) Press & hold "Mixed Loads" & "Start/Pause"
buttons together for 3 seconds
d) Press & hold "Start/Pause" button, then
press & hold "Cottons" button for 3 seconds
within 30 seconds of power on
e) None of the above
2. What function does Step 3 indicate in the Field
Service Mode for the Wizard Dryer?
a) Thermistor check
b) Sensor rods check
c) Motor check
d) Heater 1 check
e) Heater 2 check
3. The "Dryel" feature of the Wizard Dryer allows
customers to actually dry clean their garments.
T or F
4. An "E1" code for the Wizard Dryer signifies that
the thermistor is either open or shorted. T or F
5.) There is no "Model Selection Plug" for the
Wizard Dryer. T or F
Exploded parts views and list for Model DPSE592EA0.
Refer to microfiche for specific model information.
Quiz
6. To check the rod sensors, you can place your
fingers across the rods and you should mea-
sure 5 VDC at the control board 6-pin plug #5
& #6. T or F
7. The thermistor should read approximately
100K ohms at room temperature. T or F
8. During a medium heat cycle, which bias con-
tacts are activated?
a) Outlet bias
b) Inlet bias
c) Outlet & inlet bias
d) None of the above
9. What voltage is applied to the bias heater when
active?
a) 12 VDC
b) 14 VDC
c) 120 VAC
d) 0 VAC
e) 0 VDC
10. Which components are activated during the
Field Service Mode for the Wizard Electric
Dryer?
a) Thermistor, motor, heater 1, and heater 2
b) Motor, heater 1, heater 2, and drum light
c) Motor, heater 1, and heater 2
d) Motor, igniter, and ultra-care relay
– 37 –