Operating The Washer - LG WD-13519RD Owner's Manual

Hide thumbs Also See for WD-13519RD:
Table of Contents

Advertisement

Available languages

Available languages

ow to use washer
H
Once you have loaded the washer and added
laundry products (detergent, bleach, and/or fabric
softener):
❶ Press the ON/OFF button to turn on the
washer. The lights around the
cycle selector knob will illuminate.
❷ Turn the cycle selector knob to the desired
cycle. The display will show the
preset Rinse/Wash Temperature,
Spin Speed, Soil Level, and
Option settings for that cycle.
❸ If you would like to change the settings for
that cycle, press the option button(s) to
display additional settings for that option.
Press the button again to cycle through the
settings until the desired setting is highlighted.
NOTE: To protect your garments, not every
wash/rinse temperature, spin speed, soil
level, or option is available with every cycle.
❹ Select any additional cycle options, such as
NOTE: To protect your garments, not every
wash/rinse temperature, spin speed, soil
level, or option is available with every cycle.
16

OPERATING THE WASHER

STEAM or DELAY by
pressing the button for
that option.
❺ Press the START/PAUSE button to begin the
cycle. The door will latch, the
display will change, and the
washer will calculate the estimated
time remaining. Once the washer
has calculated the estimated total
cycle time, the washer will start. To pause the
cycle at any time, press PAUSE.
NOTE: The cycle time displayed may appear
much longer than that of a toploading washer.
The displayed time is for the complete cycle,
rather than just the agitation portion of the
cycle, as is typically shown on a top-loading
washer.
NOTE: If the temperature in the washer is too
high, the door cannot be unlocked until the
washer has cooled. If the water level is too
high, select the DRAIN & SPIN cycle to drain
excess water. Do not try to force the door
open.
Washing time can be reduced significantly for
small or lightly soiled loads by selecting the
Speed Wash cycle and setting the Soil Level
button to Light.
❻ When the load is finished, the beeper (if set)
will sound and the door will unlock.
Remove damp clothes from the washer
immediately. Check under the door seal for
small items.

Advertisement

Chapters

Table of Contents
loading

Table of Contents