Coleman TG9S Technical Manual

TECHNICAL GUIDE
95.5% AFUE SINGLE STAGE
RESIDENTIAL GAS FURNACES
MULTI-POSITION
MODELS: TG9S
NATURAL GAS
40 - 130 MBH INPUT
Due to continuous product improvement, specifications
are subject to change without notice.
Visit us on the web at www.york.com
Additional rating information can be found at
www.ahridirectory.org
WARRANTY SUMMARY
A 20-year limited warranty on heat exchangers in residen-
tial applications.
A 10-year warranty on the heat exchanger in commercial
applications.
Standard 5-year limited Parts warranty.
Extended lifetime heat exchanger and 10-year limited
parts warranty when product is registered online
within 90 days of purchase for replacement or closing
for new home construction.
See Limited Warranty certificate in Users Information Manual for details.
FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE
DESCRIPTION
These compact units employ induced combustion, reliable hot sur-
face ignition and high heat transfer aluminized tubular heat
exchangers. The units are factory shipped for installation in upflow
or horizontal applications and may be converted for downflow appli-
cations.
These furnaces are designed for residential installation in a base-
ment, closet, alcove, attic, recreation room or garage and are also
ideal for commercial applications. All units are factory assembled,
wired and tested to assure safe dependable and economical instal-
lation and operation.
These units are Category IV, National Fuel Gas Code and may be
vented either through side wall or roof applications using approved
plastic combustion air and vent piping. Approved plastic combus-
tion air and vent piping include Polyflue (a polypropylene venting
systems).
FEATURES
• Easily applied in upflow, horizontal left or right, or downflow
installation with minimal conversion necessary.
• Compact, easy to install, ideal height 33" tall cabinet.
• Blower-off delay for cooling SEER improvement.
• Easy access to controls to connect power/control wiring.
• Built-in, high level self diagnostics with fault code displays
standard on integrated control module for reliable operation.
• Low unit amp requirement for easy replacement application.
• Single wire twinning or staging feature available.
• All models are convertible to use propane (LP) gas.
• Electronic Hot Surface Ignition saves fuel cost with increased
dependability and reliability.
• 100% shut off main gas valve for extra safety.
• 4 speed, direct drive PSC motor.
• 24V, 40 VA control transformer and blower relay supplied for
add-on cooling.
• Hi-tech tubular aluminized steel primary heat exchanger.
• Secondary heat exchanger made of corrosion resistant stain-
less steel materials.
• Timed on, adjustable off blower capability for maximum com-
fort.
• Blower door safety switch.
• Solid removable bottom panel allows easy conversion.
• Airflow leakage less than 1% of nominal airflow at ductblaster
conditions.
• No knockouts to deal with, making installation easier.
• Movable duct connector flanges for application flexibility.
• Quiet inducer operation.
• Inducer rotates for easy conversion of venting options.
• Fully supported blower assembly for easy access and removal
of blower.
• External air filters used for maximum flexibility in meeting cus-
tomers IAQ needs.
• Protection included from air intake, exhaust vent, or conden-
sate blockage.
• No special vent termination required.
• 1/4 turn knobs provided for easy door removal.
• Internal condensate trap design (patent pending) provides
condensate management options and is self-priming to pre-
vent nuisance problems.
• Venting applications - may be installed as either 2-pipe (sealed
combustion) or single-pipe vent (using indoor combustion air).
400992-CTG-H-0615