Mounting Of Cutter Blade - Makita RBC411 Instruction Manual

MOUNTING OF CUTTER BLADE

– Insert the hex wrench through the hole in the gear case and rotate the receiver
washer (4) until it is locked with the hex wrench.
– Loosen the nut (1) (left-hand thread) with the socket wrench and remove the nut
(1), cup (2), and clamp washer (3).
Mounting of cutter blade
With the hex wrench still in place.
– Mount the cutter blade onto the shaft so that the guide of the receiver washer (4)
fits in the arbor hole in the cutter blade. Install the clamp washer (3), cup (2), and
secure the cutter blade with the nut (1).
[Tightening torque: 13 - 23 N·m]
NOTE: Always wear gloves when handling the cutter blade.
NOTE: The cutter blade-fastening nut (with coned disc spring) is a consumable
part.
If there appears any wear or deformation on the coned disc spring washer,
replace the nut.
Make sure that the blade is the left way up.
(4)
(3)
(2)
(1)
11
RBC411
RBC411U
Loosen Tighten
Hex wrench