Fault Diagnosis - Miele CVA615 Technical Information

Technical Information
6.4

Fault Diagnosis

When two cups of coffee/espresso are being prepared at the
same time, the cups are filled unevenly.
Appliance is not level.
- Level the appliance.
Coffee nozzle is dirty.
- Clean the coffee nozzle.
Brew Unit Can't be Removed from the Appliance
The brew unit is not in the starting (home) position.
- Reset the brew unit to the starting (home) position.
The brew unit is jammed and cannot be removed by resetting
the appliance (i.e. shutting the door and turning on the power).
- Perform the manual removal procedure.
Inspect the brew unit and/or drives to locate fault.
Brew Unit Cannot be Installed
The part marked PRESS was pressed during installation of the
Brew Unit..
- Do not press the part marked PRESS when installing the Brew
Unit; this only applies during Brew Unit removal.
The Brew Unit is not in the starting (home position).
- Perform a manual resetting of the Brew Unit.
The drive shaft is not in the starting (home) position.
- Reset the Brew Unit to the starting (home) position via the
Service Mode.
- Carefully inspect the Brew Unit and/or drives to locate fault
(i.e. defective switch etc...)
98
CVA615 Coffee System