Installation
Prerequisites
The following prerequisites are provided to help you install the FCA2384 HBA.
Hardware Requirements
Table 3
FCA2384.
Table 3: HBA Voltage and Minimum PCI Slot Requirements
3.3 VDC
In addition, you must use Multimode fiber optic cable with LC connector, used
with short-wave lasers.
Set Jumpers
Table 4
JX2) that control the host adapter's device ID. The default device ID is F980.
Table 4: Jumper Settings
F980
1AE5
F981
20
describes the voltage and minimum PCI slot requirements for the
HBA Voltage
Requirement
lists the FCA2384 jumper settings. The HBA has two jumper blocks (JX1,
Device ID
JX1:1-2, JX2:2-3
JX1:2-3, JX2:2-3
JX1:2-3, JX2:1-2
FCA2384 PCI-X Host Bus Adapter for OpenVMS and Tru64 UNIX Installation Guide
HBA PCI Signaling
Voltage
3.3 volt, 5 volt Tolerant
Jumper Setting
PCI Slot Type
Universal PCI connector