Cooler Operation; Before Starting; Operating The Unit - BONAIRE Durango 4500E Owner's Manual

BONAIRE WINDOW COOLER
Operation Instructions

Cooler Operation

Before Starting


Always ensure that there is another open window or door through which the air can exhaust to
other parts of the house. Refer page 5 for correct operation and ventilation.


Ensure that the filters are kept clean.


Ensure that the water to the cooler is turned on.


Ensure the plug is connected to a110V 60Hz single phase grounded appliance socket on the
inside of the house and turned on.


IMPORTANT. After the first 10 hours of operation in COOL mode, the water must be drained
from the unit water tank to remove any new product residuals. This process must be repeated
after a further 10 hours of COOL mode operation. (See page 13 for removing the over flow pipe.)
To clean the tank you must remove the Overflow Assembly Pipe. Unscrew the Overflow Nut
located underneath the cooler; remove the Overflow fitting by pulling the fitting up until it
completely removed from the tank.

Operating the unit

The Durango cooler can be operated in Manual or Auto (Remote) mode. This is selectable by the toggle
switch on the front panel. Each mode has COOL and FAN functions are available.
Manual Mode:


COOL Mode: - Move control knob to "COOL" side.
Select desired fan speed
The unit will now operate with the fan motor and
water pump activated.

FAN Mode: - Move the control knob to the "FAN" side
(pump isolated). Select desired fan speed
The unit will now operate with the fan motor only activated.


To turn the unit off, rotate the control knob to the "O" position
1 – Low/Sleep Mode
2 - Normal Operation
Max - Quick Cool down
1 – Low/Sleep Mode
2 - Normal Operation
Max - Quick Cool down
Page | 6