Setting The Date (Date Setup); Adjusting The Keypad Light Time (Time) - Silvercrest SFB 10.1 C3 User Manual And Service Information

4. Press
5. Press
6. Press
can also adjust the value by using the numeric keypad (11).
7. Press
8. Press
can also adjust the value by using the numeric keypad (11).
9. If you selected "12HR" in step 4, you can press
PM/AM setting. Press
AM.
10. Press
reads "SUCCESS" followed by "TIME SETUP".
Press to go back one menu level. To return to the start window,
press one of the device buttons.

Setting the date (DATE SETUP)

1. Press and hold the
2. Press
3. Press
4. The current date appears and the year flashes. Press the
5. Press
buttons to set the correct month.
6. Press
buttons to set the correct day. Press
display reads "SUCCESS" followed by "DATE SETUP".
7. Once the date has been set properly, in the upper right corner of the
display the abbreviated day of the week is shown.
Press to go back one menu level. To return to the start window,
press one of the device buttons.

Adjusting the keypad light time (TIME)

1. Press and hold the
2. Press
3. Press
4. Press
5-second increments between 0 and 60 seconds. If you select 0
seconds, the light remains off when any button is pressed. When set
to 0 seconds, the light can be switched on manually by pressing the
button. In this case it will light for 5 seconds.
5. Press
reads "SUCCESS" followed by "LIGHT-TIME".
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Please note that setting a longer light duration will shorten
the battery life.
, select between "12HR" and "24HR".
to toggle to time setting mode. The hour display flashes.
and select the correct value for the hour. You
to toggle to minute setting mode.
and select the correct value for the minutes. You
to confirm your entry and save the setting. The display
, select "CONFIGURE" and press
, select "DATE SETUP" and press
buttons to set the correct year.
until the month display flashes. Press the
until the day display flashes. Press the
, select "CONFIGURE" and press
, select "LIGHT-TIME" and press
to set the light duration of the remote control in
to confirm your entry and save the setting. The display
to toggle between PM and
button for 3 seconds.
to confirm your entries. The
button for 3 seconds.
SilverCrest SFB 10.1 C3
to select the
to confirm.
to confirm.
to confirm.
to confirm.
English - 83