Event Timers (Timer 1 - Silvercrest SFB 10.1 C3 User Manual And Service Information

4. Press
The display reads "SET TIMER" and suggests a delay time of 30. The
first digit flashes.
5. Use the number buttons to enter a value between 01 and 99
minutes. Press
then "SLEEP TIMER".
6. When the sleep timer is programmed, the
left of the display.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Event timers (TIMER 1....TIMER 4)
The remote control includes 4 event timers that allow the remote control to
send a preset command sequence at a set time.
1. Press and hold the
2. Press
display reads "SLEEP TIMER".
3. Press
"TIMER4" and press
The first two digits representing the hour flash. Here, you set the time
at which you want the command sequence to be sent.
4. You can use the number buttons to set a time from 00:00 to 23:59.
Use the
any mistakes. Press
The timer is always set in 24-hour format. If you have set
the remote control preferences to the 12-hour format,
please note the following:
In this case the remote control automatically converts the
24-hour format to the 12-hour format. Example: To
program a timer for 03:30PM, enter 15:30.
5. Now enter the date for the timer. You can then set the year, the
month and the day in sequence. Press
value which is currently flashing. You can use the
toggle between the different values. Press
6. Next, press the device button for the device you want and then enter
the command sequence (max. 15 commands) that you want to send
at the set time. The number of commands already entered is shown
on the left hand side of the display.
7. By default, the different timer commands are transmitted sequentially
every second. As this could be too fast for some devices, you can
adjust the delay time in 2-second increments from 5 to 41 seconds.
To do so, press the
current delay time is indicated on the display.
8. When you are done, press
reads "SUCCESS".
9. You can press up to 15 buttons per event timer, including the device
button. After this, the programming is applied automatically and the
display reads "SUCCESS".
, select "SLEEP TIMER" and press
to confirm. The display reads "SUCCESS" and
button for at least 3 seconds.
, select "TIMER" and press
, select a desired timer from "TIMER1" to
to confirm. The display shows a 4-digit time.
buttons to toggle between the 4 digits, e.g. to correct
to confirm the set time.
button, more than once, if necessary. The
SilverCrest SFB 10.1 C3
icon appears on the
to confirm the set date.
to confirm your entry. The display
to confirm.
to confirm. The
to adjust the
buttons to
English - 91