Control Panel; Operation - Formax FD 1502 autoseal Operator's Manual

CONTROL PANEL

1 Start
2 Stop
3 Ready Light
4 Counter
5 Counter Reset

OPERATION

1. Adjust fold plates to desired fold for length of paper (see fold plate adjustment on page 3). To do
this, loosen the two thumbscrews (figure 3a & b) on each fold plate. Align center bar (figure 3a & b)
so the marks on each side match up. For "V" folds remove the lower fold plate, turn around 180° and
reinstall.
2. Make sure fold plates and cover are reinstalled properly (see page 3).
3. Plug in cord and turn power on (figure 1).
4. Test fold settings. Push the paper feed lever (figure 2) down, place one form onto the in-feed table
and press the start button. Examine document and adjust fold plates if necessary (see fold plate ad-
justment on page 3).
5. Load forms. Push the paper feed lever down and load paper neatly stacked and squared on to the in-
feed table. Paper can be stacked up to 300 sheets. Note: Standard "Z" fold forms can be loaded face up
or down with the glue edge leading. All "C" fold forms must be loaded face up with glue edge leading.
6. Check that the ready light is green and press the start button to begin operation.
Figure 1
Starts machine operation
Stops machine operation
- Steady green when power is on
- Blinks red when cover is open or
fault is detected
Displays number of forms processed
Resets Counter
Power Switch
1
2
Figure 2
2
4
3
5
Paper Feed Lever