Advertisement
Advertisement
Related Manuals for Formax FD 1502 autoseal
Summary of Contents for Formax FD 1502 autoseal
- Page 1 FD 1502 AutoSeal ® OPERATOR MANUAL FIRST EDITION 6/2014...
-
Page 3: Table Of Contents
TABLE OF CONTENTS TOPIC PAGE SPECIFICATIONS, UNPACKING & SET-UP CONTROL PANEL OPERATION FOLD PLATE INSTALLATION, ADJUSTMENT SETTING CUSTOM FOLDS DAILY MAINTENANCE, TROUBLESHOOTING 5 - 6 DETERMINING FOLD TYPE INSTRUCTIONS FOR FINE-TUNING FOLDS... -
Page 5: Specifications, Unpacking & Set-Up
SPECIFICATIONS Top Cover Paper side guides Upper Fold Plate In-feed table Catch Tray Control Panel Lower Fold Plate FUNCTION: The 1502 Pressure Sealer folds and seals many different configurations including C, V, Z and custom folds. It may also use several different sizes of forms. For configuration and/or paper sizes, see listing below. -
Page 6: Control Panel
CONTROL PANEL Start Starts machine operation Stop Stops machine operation Ready Light - Steady green when power is on - Blinks red when cover is open or fault is detected Counter Displays number of forms processed Counter Reset Resets Counter OPERATION 1. -
Page 7: Fold Plate Installation, Adjustment
FOLD PLATE ADJUSTMENT Upper Fold Plate Lower Fold Plate Deflector (for Half Folds) Center Thumbscrews Throat Figure 3a Figure 3b Throat 1. To adjust the first fold remove the top cover to access the top fold plate. If the first fold is too long loosen the two thumbscrews on the upper fold plate and slide the bar down. -
Page 8: Setting Custom Folds
5. To reinstall the lower fold plate, slide the plate (with the thumbscrews facing up and throat toward inside of machine, figure 5b) until it rests on the two silver bars (figure 5a) and locks into place (figure 5c). Bars Figure 5a Figure 5b Figure 5c... -
Page 9: Daily Maintenance, Troubleshooting
2. If toner builds up on the metal sealer rollers, clean the rollers with a lint-free cloth dampened spar- ingly with a mild household cleaner. 3. Clean in-feed wheels and fold rollers with Formax-recommended roller cleaner & rejuvenator (Formax part #203) to remove paper dust and toner. A damp cloth with water is the best alternative. CAUTION: Do not use any chemicals other than the roller cleaner &... - Page 10 TROUBLESHOOTING B. Fold Quality Needs Improving: 1. Make sure paper is squared and installed correctly. Side guides should be evenly balanced and snug against the paper. 2. If folds are still incorrect adjust fold plates (see fold plate adjustment on page 3). C.
-
Page 11: Determining Fold Type
DETERMINING FOLD TYPE Two Standard Folds 11” “Z” & 11” “C” Refer to page 4 for custom fold setup. Leading glue edge Glue Glue 11” “Z” Fold 11” “Z” Fold Leading glue edge Glue Glue 11” “C” Fold 11” “C” Fold... -
Page 12: Instructions For Fine-Tuning Folds
Leading Edge Make copies of this page on copy paper for fine tuning folds Instruction For Lining Up Folds 1. Place a stack of these sheets into the feeder and fold one (1) or two (2) sheets. Leading Edge Fold “A” Fold “B”...