Installer Setting - Indoor Unit Auto-Start Setting - LG PREMTB10U Installation & Operation Manual

INSTALLATION INSTRUCTIONS
92
Installer setting – Indoor unit Auto-Start setting
It is a function that sets whether to restore the indoor unit operation by resuming the previous
power-on state or as power-off state in the power failure compensation.
If pressing button long for 3
1
seconds, it enters into Indoor unit
Auto-Start setting installer setup mode.
- If pressing once shortly, it enters into
user setup mode. Please press more
than 3 seconds for sure.
If moving to room temperature perception
2
sensor selection menu by pressing
button, it indicates as picture below.
Set Thermistor value by pressing
3
button. (00: Use indoor unit auto restart,
01: not use indoor unit auto restart)
Function Code Setting value
Press button to save.
4
Pressing button will exit settings mode.
5
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.