Installer Setting - Hold Enable / Disable - LG PREMTB10U Installation & Operation Manual

INSTALLATION INSTRUCTIONS
90
Installer setting – Hold Enable / Disable
It is a function that sets whether to use Hold mode.
If pressing button long for 3
1
seconds, it enters into Hold Enable /
Disable installer setup mode.
- If pressing once shortly, it enters into
user setup mode. Please press more
than 3 seconds for sure.
If moving to room temperature perception
2
sensor selection menu by pressing
button, it indicates as picture below.
3 Set Thermistor value by pressing
button. (00: Hold Function disable,
01: Hold Function enable)
Function Code Setting value
Press button to save.
4
Pressing button will exit settings mode.
5
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.