Connecting The Monitor - LG FLATRON 995FT Plus User Manual

Connecting the Monitor

On the back of the monitor are two plug-in connections; one for the AC
power cord, and the other for the signal cable from the video card.
1
Power off both the monitor and PC.
2
Connect the 15 pin VGA connector of the supplied signal cable to the output
VGA video connector on the PC. The connectors will mate only one way. If
you cannot attach the cable easily, turn the connector upside down and try
again. When mated, tighten the thumbscrews to secure the connection.
2'
Locate the appropriate MAC to VGA adapter block at your local computer
store. This adapter changes the high density 3 row 15 pin VGA connector to
the correct 15 pin 2 row connection to mate with your MAC. Attach the other
end of the signal cable to the side of the adapter block with 3 rows.
Connect the attached adapter block/signal cable to the video output on your
MAC.
3
One end of the AC power cord is connected into the AC power connector on
the back of the monitor. The other end is plugged into a properly grounded
three-prong AC outlet.
4
Power ON the PC, then the monitor.
5 If you see the NO SINGNAL message, check the signal cable and
connectors.
6
After using the system, power OFF the monitor, then the PC.
3
Power Cord
IBM PC
D-15P
Signal Cable
* NOTE : For Apple Macintosh use, a
separate plug adapter is needed to
change the 15 pin high density (3 row)
D-sub VGA connector on the supplied
cable to a 15 pin 2 row connector.
A2
MACINTOSH
2
Mac Adapter
D-15P
2'
M A C 6 M A C 6