Keyboard And Mouse (Wireless) - HP ENVY Phoenix 810 Troubleshooting And Maintenance Manual

Symptom
Cursor does not move
using the arrow keys on
the number keypad.
Cursor does not respond
to mouse movement.

Keyboard and mouse (wireless)

Symptom
Wireless keyboard or
mouse does not work or
is not detected.
4 Chapter 2 Troubleshooting
Possible solution
Press Num Lock on the keyboard to turn off
used.
Use the keyboard to save changes in all open programs, and then restart your computer:
1. Press the Alt+Tab keys simultaneously to navigate to an open program.
2. Press Ctrl+S simultaneously to save your changes in the selected program
shortcut for Save on most—not all—programs).
3. Repeat step 1 and step 2 to save changes in all open programs.
4. After saving changes in all open programs, press the Power button to turn off the computer.
5. After the shutdown is complete, unplug and reconnect the mouse connector to the back of your
computer, and then restart your computer.
Possible solution
Ensure that you are using the wireless keyboard or wireless mouse within range of the receiver,
●
approximately 10 meters (32 feet) for normal use, and within 30 cm (12 inches) during initial setup or for
re-synchronization.
Ensure that the mouse is not in Suspend mode, which occurs after 20 minutes of inactivity. Click the left
●
mouse button to reactivate it.
Replace the batteries in the keyboard and mouse.
●
Re-synchronize the keyboard and mouse to the receiver using the following steps.
●
The receiver, wireless keyboard, and wireless mouse shown in the following illustrations are examples; your
models might vary. IMPORTANT: During these steps, place the wireless keyboard and wireless mouse on the
same level as the receiver, within 30 cm (12 inches) of the receiver, and away from interference from other
devices.
1. Unplug the receiver from a USB connector on the computer, and then reconnect it. Your computer model
might have a connector dedicated to the receiver. If you have a choice, use a USB connector on the
front of the computer.
2. Check that the mouse is on (A), and push and hold the Connect button (B) on the underside of the
mouse for 5 to 10 seconds until the LED on the receiver lights or stops flashing. The receiver connection
session times out after 60 seconds. To ensure that the connection was established, and that the receiver
did not time out instead, move the mouse and check for response on the screen.
3. After the mouse connection is established, continue by using the steps that follow to repeat the
procedure for the keyboard.
4. Push and hold the Connect button (C) on the underside of the keyboard for 5 to 10 seconds until the
LED on the receiver lights or stops flashing.
Num Lock, so that the arrow keys on the number keypad can be
(Ctrl+S is the keyboard