Inserting A New Lens - NEC PH1201QL User Manual

Model No. NP-PH1201QL

Inserting a new lens

1. Remove the connector cover
1
2. Position the lens so that, if viewed from the front:
•
the control cable is on the left
2
•
the motor cover is on the right
3
Installation and Quick-Start Guide
: it is held in position by two screws and a key.
LENS ASSEMBLY AND FITTING
1
2
Notes
Before changing the lens, always
make sure the projector is switched
off and fully disconnected from its
power supply.
When changing the lens, avoid using
excessive force as this may damage
the equipment.
Take care to preserve the original lens
packaging and protective caps for future
use.
The projector will not power on without
the lens fitted.
3
page 16