Preparation; Prepare The Remote Control; Setting Up The Player; Select Menu Display Language - Toshiba BDX1200KE Owner's Manual

4 Preparation

Always follow the instructions in this chapter
in sequence.
Note:
-­‐ Use of controls or adjustments or
performance of procedures other than herein

Prepare the remote control

1. Open the battery compartment.
2. Insert two R03 batteries with correct
polarity (+/-) as indicated.
3. Close the battery compartment.
Notes:
-­‐ If you are not going to use the remote control
• The maximum operable ranges from
the unit are as follows.
- Line of sight: approx. 10 m
- Either side of the centre: approx. 7 m
within 30°
- Above: approx. 7 m within 30°
- Below: approx. 7 m within 30°
7 m
10
10 m 7 m

Setting up the player

Find the correct viewing input
1. Press to turn on this product.
2. Turn on the TV and switch to the correct
video-in input (refer to the TV user manual
on how to select the correct input).
Initial Setting
you need to follow these steps.
1. A welcome page will be displayed when
this product is powered on.
2. Press OK to enter language setting.
3. Select your desired language,
resolution and aspect ratio using
press OK.
4. Press SETUP to exit the Setup menu.
Use the SETUP menu
1.Press SETUP to display the Setup menu
when the Blu-ray Disc
no disc. And press SETUP to exit the Setup
menu.
Tip:
STOP SETUP

Select menu display language

.
1 Press SETUP, [General Setting] menu
is displayed.
2. Select [Language], then press
3. Select [OSD], then press
- The language options may vary for
different regions.
4. Press to select a language, then
/
press OK.
Note:
-­‐ If this disc player is connected to a HDMI CEC
automatically to the same OSD menu language
as per your TV setting.
/ , then
Player is playing or
TM
, you must press
interface.
.
.