Vivitar Vivicam 55 User Manual page 12

Note
Burst pictures are a series of pictures that are photographed in sequence. A set of
4 pictures can be taken in each capture. Flash is disabled when your camera is in
Burst mode.
To select single/burst photography in Record mode:
1.Short-press Mode button to enter the Capture mode(
appear on status LCD, press mode button to toggle the setting while the main
mode icon is blinking.
2.While the
photography selection.
Burst photography mode is indicated by the
3.Press OK button to confirm.
To select the image setting:
1.Short-press Mode button to enter the Capture mode (
If the does not appear on status LCD, press mode button to toggle
the setting while the main mode icon is blinking.
2.While the
image setting.
3.Press OK button to confirm.
Note
The number of images can be captured depends on image setting. The number of
frames can be taken as follows:
Image Setting
VGA&Fine
QVGA&Fine
VGA&Standard
QVGA&Standard
is blinking, press
is blinking, press
Indicator on Status LCD
or button to toggle the recording
icon on the status LCD.
or button to toggle the
Number of images
) .If the does not
).
26
104
91
367
EN-11