ADTRAN 3G CDMA NIM Configuration Manual page 12

3G CDMA NIM/Cellular Interface
• Source Data: Any
• Destination Data: Any
9. Once the action, source, and destination information for the ACL has been entered, select Apply. The
ACL has now been defined, and can be applied to the demand routing interface.
The ACL examples in this configuration guide are specific to using the ACLs for demand
routing interface activation and cellular connection. For more options and configurations
of ACLs, refer to the Configuring IP ACLs in AOS available online at
http://kb.adtran.com
Configuring the Demand Interface
Because the demand routing interface controls connection to the cellular network, the demand interface
must be configured for cellular network connection. To configure the demand routing interface, follow
these steps:
1. Navigate to Data > Router/Bridge > Demand Routing.
2. Select the demand 1 interface.
3. Enter the demand configuration parameters as shown:
• Resource Pool: CELLULAR
• Connect Mode: Originate
• Interface Recovery: Enabled
• Acl Name: LOCAL_LAN_OUT
• Match traffic Direction: both
• IP Address Type: Negotiated
61700801G1-29.1H
Configuring the 3G CDMA NIM Using the GUI
(article number 3087).
Copyright © 2010 ADTRAN, Inc. 12