Using Advanced - GE 25GT543 User Manual

Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels 2–13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up or down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section below.
1.
Place channels in
memory (autoprogram)
2.
Add or delete channels
3.
Press DONE to save the
setting
20
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label 13
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
English Français Español
Autoprogramming
Label 13
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label 13
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label 13
Channel Memory: 13 Erased
Cable/Air: Cable
13 A. Hook up an antenna, cable or
components before you begin
these steps or you will not be
able to add channels into
memory.
B. Press MENU repeatedly to
clear
select the Setup Menu and
highlight Autoprogram. This
menu is white.
C. Press CHANNEL down to
15
highlight Autoprogram.
+
D. Press to start the TV adding
all the channels into memory.
E. Wait until the TV has cycled
through all the channels and
returns to the original channel.
clear
A. Press MENU repeatedly to
13
select the Setup menu. This
menu is white.
B. Press CHANNEL down to
highlight Channel Memory.
C. Select the channel number you
clear
want to add or delete with the
number buttons.
+
D. Press to add or delete a
channel (you will see Stored on
13
the screen to add and Erased to
delete).
E. Repeat C and D for more
channels.
F. Press DONE to save the setting.
clear