Use Your Soundbar; Adjust The Volume; Adjusting The Volume (Default: Level 10) - Sanyo FWSB405FS Owner's Manual

Adjust the volume

Adjusting the volume (default: level 10)

1) To increase or decrease volume, press VOL +/- on remote control.
• To mute sound, press
– When the mute on, the POWER indicator on the front panel of main unit blinks in red.
– When the mute off, the POWER indicator stop blink and light off.
• To restore the sound, press
Volume LED display
0 ∼ 5
6 ∼11
12∼ 17
18∼ 23
24∼ 29
• When pressing [VOL+/-], the indicator will show the current volume. Pressing [VOL+/-] while the current volume is shown will
increase/decrease the volume.
• Pressing and holding [VOL+] or [VOL-] will increase or decrease the volume and the indicator will blink. When the volume has
reached the maximum or minimum, the indicator will stop blinking.
Note(s):
• The volume might be infl uenced by MP3 or Bluethooth player. If the volume is too low, adjust the volume on the connected device.
• If the volume level is set above 15 when the Soundbar is turned Off, the volume will automatically be reset to 15 when the
Soundbar is turned back On.
EN

Use your Soundbar

on remote control.
again or press VOL +/-.
Lights up for 3 seconds (default: level 10)
Behavior
– 11 –