Heat & Glo T-HVBI-AUB Owner's Manual page 36

Figure 49. Mounting Remote Control Housing
AUX300CE Module Installation
• Insert the 4 hole harness from the AUX300CE module
into the 4 pin plug on the control module. See Figure
50.
CONTROL MODULE
Figure 50. AUX 300 module installation
Fan Installation
• Insert the 3 prong plug from the fan into the
receptacle located in the AUX300CE module. See
Figure 51.
• Insert 3 prong plug from AUX300CE module into
REM/AUX receptacle of fireplace junction box.
AUX 1: AUX 2: 3 PRONG PLUG (FAN):
3 steps, HIGH, ON/OFF 3 steps, timer based,
MED and LOW 3 min. ON, 12 min. OFF
AUX 300
MODULE
Figure 51. Plug Fan into AUX300CE Module
36
AUX 300CE
CABLE
FAN CORD
Heat & Glo • ST-HVBI-AUB • 2082-980 Rev. R • 9/15
Programming the RC300AU to the Control
Module
CAUTION! Risk of burns! DO NOT program the re-
mote control to the control module when fireplace is
hot.
• Verify the ON/OFF/REMOTE switch is in the
REMOTE position. Green LED light will blink three
times and the control module will beep once 5
seconds later when ready. See Figure 52.
• Using a small item (such as a paper clip) press and
release the LEARN button located near the ON/OFF/
REMOTE switch. See Figure 52.
• Control module will beep once and LED will blink
green for 10 seconds.
• While the LED is blinking, press the POWER button
on the remote control. A double beep will come out
of the control module to indicate that it has been
programmed successfully.
NOTICE: Up to three remote controls can be
programmed into the control module. Simply press
a button on the other remote controls during the 10
second programming process to add another remote
into the system. It is recommended to program only
one RC300AU remote control.
To clear memory in the control module, use a small
item (such as a paper clip) to press and release the
LEARN button. Control module will beep once and
LED will blink green for 10 seconds DO NOT press
any buttons on the remote during the ten seconds that
the green LED blinks. The memory will be cleared.
Note that the RC300AU will not be programmed if it's
in STANDBY mode. Press the ON/OFF button twice to
switch to IDLE mode.
REMOTE POSITION
Figure 52. Programming RC300AU
LEARN BUTTON