Table of Contents
Advertisement
Forms are fed but there is still a
problem.
Is the paper thickness lever set
correctly?
Yes
Is the paper select lever set
correctly?
Yes
Are forms fed smoothly?
No
Are unspecified or abnormal forms
used?
No
Are forms positioned correctly?
Yes
Is something blocking the feed
path?
No
• Defective printer control board
• Defective paper feed motor
• Defective platen unit and other
forms feed mechanism
Forms are fed smoothly but there is
still a problem.
Is the length of the forms fed too
long or short?
No
End
[Normal operation]
No
Set the paper thickness lever
correctly.
No
Set the paper select lever correctly.
Yes
See the entry below.
Yes
Replace forms with specified or
regular forms.
No
Load forms correctly.
Yes
Remove obstacles from the feed
path.
Yes
Check the page length setting in
setup mode.
Advertisement
Table of Contents
