GE JGP336 Installation Instructions Manual page 13

G
Making the L.P. Conversion
Safety Information you
G1
should know
The pressure regulator and burner orifices
are set for natural gas. To use Propane
Gas, the regulator and burner orifices
must be converted. The LP orifice spuds
for the cooktop burners can be located
within a bracket attached to the pressure
regulator of this unit.
CAUTION: The cooktop, as shipped
from the factory, is set for use with
natural gas. If you wish to use your
cooktop with Liquefied Petroleum
(Propane) gas, you must first replace
the orifices and convert the pressure
regulator.
WARNING: This conversion must be
performed by a qualified installer or gas
supplier in accordance with the
manufacturer's instructions and all codes
and requirements of the authority having
jurisdiction. Failure to follow instructions
could result in serious injury or property
damage. The qualified agency performing
this work assumes responsibility for the
conversion.
LP Conversion
To adjust your cooktop
G2
for use with LP gas,
follow these instructions:
CAUTION: The following adjustments
must be made before turning on the
burner. Failure to do so could result
in serious injury. Be sure pressure
regulator has been converted as
described in Step G2.
a. Disconnect all electrical power, at the main
circuit breaker or fuse box.
b. Shut off the gas supply to the cooktop by
closing the manual shut-off valve.
c. Adjust the pressure regulator, by the
following instructions:
• Unscrew the cap.
• Place your thumb against the flat side of
the spring retainer and press down to
remove the retainer.
• Carefully look at the spring retainer to
locate the NAT or LP position.
NAT
NAT
NAT.
POSITION
PRESSURE REGULATOR
• Turn the spring retainer over so that
LP is showing on the bottom.
• Snap the retainer back into position.
13
GASKET
CAP
LP
SPRING
RETAINER
LP
L.P./PROPANE
POSITION
continued on following page