Kenmore 253.6000 Series Use & Care Manual page 9

First Steps
3. Attach toe grille to cabinet.
(some models)
To level the cabinet using the front rollers:
1 Remove the toe grille.
2 Use a flat-blade screwdriver or ⅜
inch socket wrench to raise or lower
the front rollers (Figure 2). Do not
raise the cabinet more than 9/16 inch.
9/16"
Max
Figure 2
3 Use adjustable wrench to adjust
leveling screws. Lower the leveling
screws on each side clockwise until
they contact the floor (Figure 3). Do not
raise the cabinet more than 9/16 inch.
or
Raise
or
9/16"
Max
NOTE
Raise the front of the refrigerator enough
so the doors close freely when opened
halfway. The refrigerator should slope ¼
inch to ½ inch from front-to-back. Then
level the refrigerator from side-to-side.
4 Some models are equipped with an
anti-tip bracket (Figure 4). Lower it
clockwise until it contacts the floor.
Anti-tip
Bracket
Figure 4 (some models)
WARNING
The anti-tip device must be
installed according to the
instructions in your Use &
Care Manual. Failure to do
so will result in injury.
WARNING
When reversing the door swing:
You MUST move the anti-tip bracket
to align with the hinges of the door.
Failure to do so will result in injury.
9
Raise
Figure 3
Lower