Specifications - Sharp XG-C50X Service Manual

XG-C50X

Specifications

Product type
Video system
Display method
LCD panel
Standard llens
Projection lamp
Component input signal
(INPUT1/2)
Horizontal resolution
Computer RGB input signal
(INPUT 1/2)
Video input signal
(INPUT 3)
S-video input signal
(INPUT 4)
Computer control signal (RS-232C)
Pixel clock
Vertical frequency
Horizontal frequency
Audio input signal
Audio output
Speaker system
Rated voltage
Input current
Rated frequency
Power consumption (normal)
Power consumption (standby)
Heat dissipation
Operating temperature
Storage temperature
Cabinet
I/R carrier frequency
Dimensions (approx.)
Weight (approx.)
Supplied accessories
Replacement parts
* Temporary noise may be visible with vertical frequencies above 100Hz if OSD functions are activated.
This SHARP projector uses a LCD (Liquid Crystal Display)
panel. This very sophisticated panel contains 786,432 pix-
els (× RGB) TFTs (Thin Film Transistors). As with any high
technology electronic equipment such as large screen TVs,
video systems and video cameras, there are certain accept-
LCD Projector
Model XG-C50X
NTSC 3.58/NTSC 4.43/PAL/PAL-M/PAL-N/PAL 60/SECAM/
DTV480I/DTV480P/DTV540P/DTV580I/DTV580P/DTV720P/DTV1035I/DTV1080I
LCD panel × 3, RGB optical shutter method
Panel size: 0.99" (25.1 mm) (15 [H] × 20 [W] mm)
No. of dots: 786,432 dots (1,024 [H] × 768 [V])
1–1.27 × zoom lens, F1.7–2.2, f = 36.5–46.3 mm
AC 250 W lamp
15-pin mini D-sub connector
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
P : 0.7 Vp-p, 75Ω terminated
B
: 0.7 Vp-p, 75 Ω terminated
P
R
750 TV lines (DTV720P)
15-pin mini D-sub connector
RGB separate/sync on green type analog input: 0–0.7 Vp-p, positive, 75Ω terminated
HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative)
VERTICAL SYNC. SIGNAL: Same as above
RCA connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75Ω
terminated
4-pin Mini DIN connector
Y (luminance signal): 1.0 Vp-p, sync negative, 75Ω terminated
C (chrominance signal): Burst 0.286 Vp-p, 75Ω terminated
9-pin mini DIN connector
12–230 MHz
43–200 Hz*
15–126 kHz
ø3.5 mm minijack: AUDIO, 0.5 Vrms, more than 47 kΩ (stereo)
3.0 W (monaural)
4 cm × 7 cm
AC 100–240 V
3.4 A
50/60 Hz
340 W (Standard mode)/290 W (Low power mode)
About 0.8 W (When "Mntr.out/RS232" is set to "OFF")
1,280 BTU/hour
41°F to 104°F (+5°C to +40°C)
–4°F to 140°F (–20°C to +60°C)
Plastic
38 kHz
" × 3 " × 11 " (390 (W) × 99.0 (H) × 294 (D) mm) (main body only)
15 3 ⁄ 7 ⁄ 9 ⁄
8 8 16
" × 4 " × 11 " (393 (W) × 114.0 (H) × 303.2 (D) mm) (including adjustment foot
15 1 ⁄ 7 ⁄ 5 ⁄
2 16 8
and projecting parts)
10.8 lbs. (4.9 kg)
Remote control, Two R-6 batteries, Power cord for U.S., Canada etc. (11'10", 3.6 m), Power
cord for Europe, except U.K. (6', 1.8 m), Power cord for U.K., Hong Kong and Singapore (6',
1.8 m), Power cord for Australia, New Zealand and Oceania (6', 1.8 m), RGB cable (9'10", 3
m), USB cable (9'10", 3 m), Computer audio cable (9'10", 3 m), DIN-D-sub RS-232C adap-
45
tor (6 ⁄ ", 15 cm), Extra air filter, Lens cap (attached), Dust cover, Projector manual and
64
technical reference CD-ROM, Sharp Advanced Presentation Software CD-ROM, Operation
manual, Quick reference label
Lamp unit (Lamp/cage module) (BQC-XGC50X//1), Remote control (RRMCGA029WJSA),
Two R-6 batteries ("AA" size, UM/SUM-3, HP-7, or similar), Power cord for U.S., Canada etc.
(QACCDA010WJPZ), Power cord for Europe, except U.K. (QACCV4002CEZZ), Power cord
for U.K., Hong Kong and Singapore (QACCBA012WJPZ), Power cord for Australia, New
Zealand and Oceania (QACCL3022CEZZ), RGB cable (QCNWGA012WJPZ), USB cable
(QCNWGA014WJPZ), Computer audio cable (QCNWGA013WJPZ), DIN-D-sub RS-232C
adaptor (QCNWGA015WJPZ), Air filter (PFILDA005WJZZ), Lens cap (PCAPHA003WJSA),
Dust cover (GCOVDA001WJZZ), Projector manual and technical reference CD-ROM
(UDSKAA007WJZZ), Sharp Advanced Presentation Software CD-ROM (UDSKAA005WJN1),
Operation manual (TINS-A163WJZZ), Quick reference label
Specifications are subject to change without notice.
able tolerances that the equipment must conform to.
This unit has some inactive pixels within acceptable toler-
ances which may result in inactive dots on the picture
screen. This will not affect the picture quality or the life ex-
pectancy of the unit.
2