JVC HA-RF100S Service Manual page 13

HOW TO USE
How to use the speakers
1. Connect the transmitter and AV equipment. (Refer to page 10)
2. Connect the AC adaptor to the transmitter, then plug the AC adaptor into an AC
outlet. (Refer to page 11)
3. Turn on the power on the transmitter and the connected AV equipment.
Transmitter power
When an audio signal is input, the transmitter's power is turned on automatically, and the
indicator lights in green. Also, when no audio signal is input for about a minute, the
indicator goes out automatically and the power turns off. (Automatic Power On/Off function)
In some situations, the power may not be turned on automatically by the input sound (e.g. a
song with a quiet opening or gradual fade-in). This is not a malfunction.
4. Turn the knob clockwise to turn on the
speaker power and to control the
volume.
20
5. Push the AUTO TUNING switch control to get the best reception in the
speakers.
When the button is pressed, frequency tuning starts automatically and it stops
when a signal is detected.
In cases of interference or
too much noise, turn the
TUNING control on the
transmitter to another
position, then repeat step 5.
6. Press the BASS BOOST (BOOST
BASS) button when the bass is not
enough. The bass can be emphasized.
After use
Turn the knob counterclockwise until the click sound is heard to turn off the speaker
power. The red light of the power indicator goes out.
(OFF) MIN. MAX.
VOLUME
HOW TO USE
AUTO
ST
TUNING
S
NORMAL BOOST
BASS
21